4 Febs on lyocmsrpi02,03,04,05

Firmware version 20042018_17:00

Channel 23 is now connected to PETIROC input 19 (from 0) instead of 11

Database version is FE1_24CH_30 (all DAC6B from 11 to 19 are set to 31)

— DAQ user 2018/04/25 22:09

Run 740010 calibration all together (really noisy) Q: is there any HV ?

Run 740011 calibration strip by strip on going

— DAQ user 2018/04/26 09:02

Mistake in the configuration the state was FE1_24CH_27 instead of 30

Calibration repeated with

daqcontrol --daq-downloaddb ----dbstate=FE1_24CH_30

New run one/one 740016

— DAQ user 2018/04/26 11:31

Ok a bit noisy but the mapping is wrong we lost completly the strip 12. We switch back to previous mapping

— DAQ user 2018/04/26 16:39

Christophe added ground and trigger cables

firmware with old coax mapping

pedestal run all togeher : 740108

VTH cut = 507

Physics run:

• Top= 1000 V (0.0), Bottom =6000 V (0.0) ⇒ 740110

— DAQ user 2018/04/26 16:43

WEBDCS is playing with HV I go back to Lyon

— DAQ user 2018/04/27 14:43

Le nouveau firmware ne marche pas on revient sur TDC_DAQ_24CH_CLK

On fait quelques runs source Off