test_febv2_petiroc2c
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
test_febv2_petiroc2c [2021/11/02 13:59] acqilc [Mesures au beam dump 02/11] |
test_febv2_petiroc2c [2021/11/03 05:40] (current) acqilc [Mesures au beam dump 02/11] |
||
|---|---|---|---|
| Line 198: | Line 198: | ||
| We then set the HV to 7.1 kV and try a run 1255 in /data/beamdump/raw | We then set the HV to 7.1 kV and try a run 1255 in /data/beamdump/raw | ||
| + | --- //[[laurent.mirabito@gmail.com|DAQ user]] 2021/11/02 14:33// | ||
| + | For the moment no beam so difficult to conclude | ||
| + | Few beam seen but weird trigger | ||
| + | Run 1256 idem with good trigger but still weird data | ||
| + | I create a "bad" state with alignement with autoreset but FPGA reset settings it's version RE41_188_FEB_6_BeamDump_LM 3 | ||
| + | Run 1257 is with this state, not a single channel seen except 32 (BC0) and 33 (Trigger) | ||
| + | |||
| + | --- //[[laurent.mirabito@gmail.com|DAQ user]] 2021/11/03 05:37// | ||
| + | |||
| + | State RE41_188_FEB_6_BeamDump_LM 4 is identical with trehsold = Target +10 | ||
| + | |||
| + | Lot of channels seen but only on FPGA 0 and first channels (0-10) | ||
test_febv2_petiroc2c.1635861542.txt.gz · Last modified: 2021/11/02 13:59 by acqilc
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
