Differences

This shows you the differences between two versions of the page.

--- test_febv2_petiroc2c [2021/11/02 12:54]
acqilc [Mesures au beam dump 02/11]
+++ test_febv2_petiroc2c [2021/11/03 05:40] (current)
acqilc [Mesures au beam dump 02/11]
@@ Line 180: / Line 180: @@
   dac6bConfig_FEB6_188_all/
+The channels and summary png are in the same directory
 We observe a noise ~ 45-55 DAC10B counts (a bit high)
+Here the turn on is around 455 and the target is 409 , so 45 DAC
+{{ :petiroc2c:scurve_channels_fpga_2_top_1635856021966.png |}}
+We repeat the run with different grounding  run 1635857964615
+Same results so we create a state in DB
+  RE41_188_FEB_6_BeamDump_LM
+Version 2 is load with Scurve studies alignement and +60 from Target
+We then set the HV to 7.1 kV and try a run 1255 in /data/beamdump/raw
+ --- //[[laurent.mirabito@gmail.com|DAQ user]] 2021/11/02 14:33//
+For the moment no beam so difficult to conclude
+Few beam seen but weird trigger
+Run 1256 idem with good trigger but still weird data
+I create a "bad" state with alignement with autoreset but FPGA reset settings it's version RE41_188_FEB_6_BeamDump_LM 3
+Run 1257 is with this state, not a single channel seen except 32 (BC0) and 33 (Trigger)
+ --- //[[laurent.mirabito@gmail.com|DAQ user]] 2021/11/03 05:37//
+State  RE41_188_FEB_6_BeamDump_LM 4 is identical with trehsold = Target +10
+Lot of channels seen but only on FPGA 0 and first channels (0-10)

IP2I CMS Wiki